PRC Polaris Ranger Club banner

factory brush guard diameter

871 views 5 replies 4 participants last post by  jtmoney 
#1 ·
I'm trying to find a bracket for my ranger so I don't have to drill holes in the brush guard. Anyone know the diameter? Thanx
 
#3 ·
Wasn't long ago someone posted this exact same thing. I'm amazed at how difficult it must be to just pull a tape measure out.
 
  • Like
Reactions: Naylor649
#4 ·
It's either 1.5" or 1.75". Measure the circumference, if it's 4.75" the diameter is 1.5". If it's 5.50", the diameter is 1.75" (Circumference/Pi=diameter).
 
  • Like
Reactions: 41602
#5 ·
Upper type is 1.75
The lower brace tubes are 1.5
Land vehicle Tire Automotive tire Vehicle Automotive exterior
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top