PRC Polaris Ranger Club banner
Cancel

2006 RANGER IDLE BUT WILL NOT ACCELERATE HELP!

879 Views 7 Replies 3 Participants Last post by  Jungleman, 
N
Need a little help. I have a 2006 ranger xp 700 little back story it was in a flood back in 8/17/2021. after the flood completely went tru and repalced all fluids and filters.
ran fine till summer then it quit moving would idle fine but touch the pedal and die. Have changed injectors, harnesses, tps, crank sensor, plugs, wires and filters and fluids again.
Still nothing. i have been told that the module is the problem #4011370 but i have yet to find one. fuel pressure is 40# and have set the tps sensor and tried everthing.. so any help at this point would be greatly appreciated. i will run and rev up off of starting fluid, i have traced the harness the best i can and looked for a problem but so far nothing.
Reply
Save
Like
1 - 3 of 8 Posts
N
ok yes tank has been dumped twice and wiped clean all are oem parts. the tps was set when intatalled and i havent looked at the flow. i still think that theres a bad wire
and not letting the ecm read the tps. but i am not sure i have traced the wires and looked for noticeable things. lol been at this since april it was shut off after hauling wood and never moved since
but i have tried when ever possible to use oe parts
Reply
Save
Like
N
SET WITH A OEM METER AND 61 IS THE ONLY CODE
Reply
Save
Like
1 - 3 of 8 Posts
PRC Polaris Ranger Club
PRCforum is the best Polaris forum community to discuss RZR 1000, Crew 900, PRC Ranger Club, XP 900, RZR XP 4 900, RZR 570, HD, 170, RZR-S, XP 900, RZR XP 4 900, ORV, side by side, SSW and off-road information.
Full Forum Listing
Explore Our Forums
Ranger Discussions General Member Discussions Ranger Technical Ranger XP 900 & 570 FS Discussions RZR Discussions
Top