Mr, half a turn will normally get it done . How far do you need to go to lose all drag ? Did you just install new pads ? I always clean & grease the slides when I have the calipers off.
2006 ranger xp700 front brake adjustment
If I seat the Allen nut on the caliper, then back it out 1/2 turn there is way to much drag on the hub. So I keep backing it out until the drag is gone but is this ok to do?
1 - 2 of 5 Posts
I see no problem Mr. with 1-1/2 turns although I would check em after you get a few miles on the new pads ..
1 - 2 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
PRC Polaris Ranger Club
PRCforum is the best Polaris forum community to discuss RZR 1000, Crew 900, PRC Ranger Club, XP 900, RZR XP 4 900, RZR 570, HD, 170, RZR-S, XP 900, RZR XP 4 900, ORV, side by side, SSW and off-road information.
Full Forum Listing
Recommended Communities
