PRC Polaris Ranger Club banner
1 - 4 of 4 Posts

·
Administrator
Joined
·
7,841 Posts
James, that TB adapter appears to have been going bad for a while. Get a can of carb cleaner and take that throttle body off and clean it and check the airbox for oil stained filter...and>>>>>>>>>check the air box boot for a crack/tear right around where the TBAP sensor goes in. Clean the TBAP sensor with the carb cleaner also... Then do a compression test as RJ said. Both plugs out........wide open throttle and look for 150 psi..
 

·
Administrator
Joined
·
7,841 Posts
James, I believe you will need a 14mm adapter for tthe compression tester..
 

·
Administrator
Joined
·
7,841 Posts
My CT came from HARBOR FREIGHT and included ALL sizes ......about 20 bucks....
 

·
Administrator
Joined
·
7,841 Posts
James, BOTH plugs out ..........WIDE OPEN THROTTLE .........spin about the same number of revolutions per .... I donot disable the injectors but you could if you want to. It would be nice if the motor was warm but that is tough if the engine wont start .. 1 fifth of PATRON is adequate ..

Unbolt the TBAP I think it is a 3/8 wrench and PULL out the sensor........PULL HARD...
 
1 - 4 of 4 Posts
Top