PRC Polaris Ranger Club banner

2015 ranger 570 eps mid size wipers

2469 Views 8 Replies 4 Participants Last post by  ddpollary
I ordered a polaris wiper/washer kit and installed per directions. Nothing works after install. They say to connect the 3 wires to the buss bar. There are 3 wires (Orange/white, red & brown). I have no power to anything. I've tested the washer motor directly and it works. I'm not sure what I'm doing wrong. This is the second one with the same results. Very frustrated. Any help would be appreciated. I get no help from my dealer or polaris because I am an end user and not a dealer.
1 - 9 of 9 Posts
Welcome to PRC!
If the buss bar you are referring to is the one with 3 terminals (probably under your hood), it's probably not wired. Polaris used to wire all three terminals on the older models, but lately, they only wire one, the "keyed hot" terminal. Not sure if this true on the new 570's or not. Easy to test with a meter or test light. If the other two terminals are not wired, you can order a harness from a dealer or make one up yourself.

P.S. If your dealer won't help you out with this type of problem, he's a jerk - I would tell him to pack sand then find another dealer.
On my 570 the top one is keyed hot, the other 2 are dead.
One should be keyed hot, i think its orange? The other one is constant hot, oughta be red, and one is ground. If only keyed hot is on, then thats the hard one. Just get a wire coming from the battery for your constant hot (FUSE IT!!) and then a ground from either the frame right there at the bus bar, or run a ground wire up from the battery.

HOWEVER...look around a little bit..you may find a wire or wires from the fusebox to run to that bus bar. mine come right over from the fuse box to the bus bar.
thank you very much for the information. My top one of the 3 is keyed hot. I will look into the wiring harness and might also look to see how easy it might be to wire myself. My dealer just told me that he can't help me because they did not do the install.
I will say the members here at PRC are great. It's nice to see the help and responses from you guys.
thank you very much for the information. My top one of the 3 is keyed hot. I will look into the wiring harness and might also look to see how easy it might be to wire myself. My dealer just told me that he can't help me because they did not do the install.
id tell yoru dealer to pound salt or suck eggs...If he's not reliable enough to hook up a wire...i sure as heck wouldnt trust him to do ANYTHING else...at all!!

let us know if ya need any other help!!
I will. I appreciate the help ALOT.
The wiring tips worked. I ran another hot from the battery to the terminal and ran a ground and they work fine. Thanks
  • Like
Reactions: 2
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top