PRC Polaris Ranger Club banner
1 - 6 of 6 Posts

·
Registered
Joined
·
91 Posts
Discussion Starter · #1 ·
while hooking up some spot lights this weekend ,i found a 9 volt batt connector taped to the wiring harness on rt side under hood compartment. anybody know what it goes to. 07 6x6 thanks rob.
 

·
Special Advisor
Joined
·
8,943 Posts
It is for the cumputer hook up when they run a test on your ranger. They put the battery in it so it has constant power for the test. Hope this helps.
 

·
Registered
Joined
·
23 Posts
I came across this too, while installing some HID lights on my ranger, Well, being a Rocket Scientist and all, I plugged a 9 volt battery into the connection. 3 hours later, when I went to start my Ranger, and check out my new lights.....crank but no start. The good news is it only took 2 beers, 1 cigar, and 32 minutes to figure it out. Wow, that was close!

Regards, Rick
 

·
Registered
2009 Polaris Ranger 700 XP
Joined
·
100 Posts
whitewing hunter, I was doing the same thing as you and I didn't know either. I was going to ask the same question......Thanks
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top