PRC Polaris Ranger Club banner
1 - 6 of 6 Posts
G

·
Discussion Starter · #1 ·
OK. I've been riding sport quads for the last 3 years now and I'm moving up to a RZR. Here's my question. On my sport quad if I happened to get a flat I could limp back to the truck while still riding the quad.

How about with the UTV or the RZR. Since it weights quite a bit more than my sport quad will it hold up enough to get me back to the truck?

I will of course be carrying a plug kit and a compressor but let's say I tear a hole in the side wall or bend a rim and loose the bead. Have any of you found yourself in this situation?
 

· Registered
Joined
·
744 Posts
Excellent ????

Having just seen it, I would highly recommend the spare tire carrier for the back of the Razor. It not only offers storage for a spare tire but also helps build an enclosure for the small rear bed.

freddy
 

· Registered
Joined
·
20,463 Posts
No, it will not make it back to the truck.....not without having to buy a new rim when you get there. It'll likely be off of the bead within a hundred yards or so. Better carry a spare....at bare minimum, a plug kit and compressor.
 
G

·
Discussion Starter · #4 ·
That's what I thought. I guess I'll be picking up a spare tire and wheel also then.

Dealer is only getting in 1 set of 14" tires and rims but I can always strap two of the stock tires and rims in the bed until I get the proper size spare.

Thanks!

AL
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top