[rockn h]

I'm trying to adjust the toe-out on my 2010 800XP. The 800 doesn't have any where on the tie rod to put a wrench like some other Polaris' do. So here's my question I need help with. Does the tie rod on the 2010 800XP thread into the rack, so you need to turn the tie rod and get adjustment on both ends, or do you just turn the outer end?
Thx

 

[Expat]

I just disconnected the ends and turned each side equal turns, reinstalled and measured, repeat. Steering wheel stayed straight.

 

[commanderjjones]

Look really close. Unless they changed it in later years, there "should" be some flat spots where a wrench can be used. If memory serves, it was around the middle of the tie rod. All of the old body style ('08 and back) had it, and I worked on a buddies 2011 XP that was the same. You just have to look closely......the flats spots aren't very noticeable.

 

[rockn h]

Jerry you were right.... finally found it. The flat spots are about an inch in from the threads on mine. Had to feel it and then see it. I must be going blind. LOL thanks