PRC Polaris Ranger Club banner


5620 Views 7 Replies 5 Participants Last post by  skenneyjr
I have an 05 ranger 700 that is melting all of the plastics in front of the motor. I did a search and found a few people that have heat problems but this seems much more severe. I just finished checking the plugs and they are bright white-looks too lean. I dont have any engine,exaust or intake mods-all stock. The wrench light is not on or flashing (only on with key on engine off). Is there a way to check for diag codes on an 05? Any input would be great. Also, if anyone knows of a link to a pdf service manual that would be fantastic.
1 - 1 of 8 Posts
if all else fails just put in more heat shields
my 500 started melting stuff and the foil fell off, i just replaced it, doubled the layers, and was good to go
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.