I shortened mine 3". The best place to do it is in the straight part on the front half of the cage, near the bottom and in the rear section just above the headrest crossbars. If you need it I can tell you how to do the whole procedure.
Ever cut down a roll bar?
Has anyone ever shortened a roll cage on a Ranger? I've found a great deal on some enclosed trailers in Muskogee, Oklahoma (Sooner Sales) but the doors aren't tall enough. When I sit in my 07 XP I have 6" of clearance between the top of my head and my new aluminum roof.
Is 3" enough head clearance? Would it make it hard to get in and out of? Would I bump my head on a rough trail?
These trailers have hale damage (Not much at all) and 12' & 14' & 16' are around $2,500.00 with ramp doors double doors are a lot cheaper and they have around 2 or 3 hundred of them. One 16' with double doors was $1,850.00 and I think all of them have the side doors.
Is 3" enough head clearance? Would it make it hard to get in and out of? Would I bump my head on a rough trail?
These trailers have hale damage (Not much at all) and 12' & 14' & 16' are around $2,500.00 with ramp doors double doors are a lot cheaper and they have around 2 or 3 hundred of them. One 16' with double doors was $1,850.00 and I think all of them have the side doors.
1 - 1 of 17 Posts
1 - 1 of 17 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
PRC Polaris Ranger Club
PRCforum is the best Polaris forum community to discuss RZR 1000, Crew 900, PRC Ranger Club, XP 900, RZR XP 4 900, RZR 570, HD, 170, RZR-S, XP 900, RZR XP 4 900, ORV, side by side, SSW and off-road information.
Full Forum Listing
Recommended Communities
