PRC Polaris Ranger Club banner

1 - 8 of 8 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
bought this machine and looks like needs a motor or full rebuild. Low compression in at least 1 cylinder and don't get a whole lot of smoke out of it. At shop right now getting fully diagnosed but want to see if there is a good used one out there. I can get a new one from Kohler for about $3500 but have to wait 3 or 4 months for it.

If not local I will pay for shipping as long can get it strapped to a pallet.

Thanks!!
 

·
Registered
Joined
·
1,121 Posts
I wouldn't go that route. Check out one of our sponsors here. Probably cheaper also.

 

·
Registered
Joined
·
2 Posts
Discussion Starter #6
$3500 wouldnt be that bad but don't want to wait 4 months for it to get built and shipped. Motorsports Nation only has a few pizza parts for that motor. NFlow looks like have motor but its reman.

Might have to go that route because of the straight time involved. Doesnt do me any good sitting in the garage as a paper weight.....
 

·
Registered
Joined
·
2,749 Posts
I don't think you can go wrong with an nFlow remanufactured engine. Rebuilding is their business.
 
1 - 8 of 8 Posts
Top