PRC Polaris Ranger Club banner

My FergFab Rear Seat and Cage Install (More PICS!)

3226 Views 7 Replies 4 Participants Last post by  phoenixbob
<font color="red">This is an old post that I moved from the other forum, the original post was dated February 02 2007</font id="red">

Yesterday I installed my FergFab goodies which included the following: rear seat and rear seat mount, rear cage extension, cooler rack with floor, soft top, and 5 Crow 4-point harnesses. Let me just say that the craftsmanship was top notch and the service was outstanding. Everything fit excellent, and the powder coating appears to be of a very high quality. I was able to fit the soft top around my 5 panel wink mirror, which was a concern when I was ordering because it is cut out for their billet mirror. The only issue I had was the fact that nothing came with instructions. Most of the install is pretty self explanatory, but there were a few things that I had to double check with John at FergFab on just to make sure I was doing it right. John was always helpful and friendly, so it was more of an inconvenience than a problem, but a short instruction sheet would be a nice addition just in case you're installing the stuff after business hours. I am kind of concerned with the mounting positions of the rear outboard lap belts and have posted a picture of that as well. The tab has to be mounted at a funny angle to fit under the edge of the seat frame, other than that, everything is perfect.

I am extremely happy with everything so far, and have the thing at the boat top shop having a little extra done to it right now, I will post pics of that later!



See less See more
1 - 1 of 8 Posts
That's a great looking rig, I'm thinking about doing that if I end up with a Ranger.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.