PRC Polaris Ranger Club banner
1 - 3 of 3 Posts

·
Registered
Joined
·
169 Posts
Discussion Starter · #1 ·
I have some TrailTech HID lights mounted on billet brackets near the top of my rollbar. THey stick out from the bar approx. 3 inches or so and thus sometimes get whacked by branches.

I was looking for something to bolt on and protect them and found these bars that seem perfect. The problem is that they only stick out about 2 5/8 inches from the bar that they are mounted on. Since my lights stick out farther than this, they will still get hit by branches.
http://www.tellico4x4.com/product_i...15782?osCsid=4eae5cde528d768f5ef2e032f7a79b92

Can you fab up something like this, using bolt on brackets, to protect my lights?

Anyone else?

Thanks for the help.
 

·
Registered
Joined
·
100 Posts
I've actually got one like that in my rig but I used a entry handle off of a CAT skidloader and bolted it through my RW windsheild frame. I just took one off of one of my rigs but I'm sure you couls buy one through CAT fairly cheap.
Corey
 

Attachments

1 - 3 of 3 Posts
Top