PRC Polaris Ranger Club banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I just finished the install of power steering to my 2019 570 Mid size. I have connected all of the wiring to the dash components. When I went to start it, nothing happens. I am depressing the brake pedal. After a good night's sleep. I realized that there is a gray "wedge" that I think lays on the female coupler that all then gets inserted into the female coupler for the ignition switch. I foolishly did not take a photo before disconnecting. Could the absence of the wedge cause no contact current to be passing?

I see that the wedge has two small tits that look like they should lone up with two holes in the male casing.

Any thoughts folks?

Thanks,
JB
 
1 - 3 of 3 Posts
Top