Bump after edit
Pro lift install
I installed the pro lift 2" lift with 28" maxxis bighorns today.. I've got a couple of questions for you guys... Now that I've put it on I can see that my steering tie rod ends are close but not touching...will that be an issue? Also, while putting on the from tires I noticed that the strut is still moving up and down in the strut body...I tightened both of those down good. Do I need to tighten more or will this right itself with time? Or is this normal?
1 - 4 of 4 Posts
The strut should not be moving. You'll have to tighten it up. It's not unusual for the tie rod ends to be close. Mud can damage the rubber covers. If it's too close you may need spacers or wheels that are offset more.
The strut should not be moving. You'll have to tighten it up. It's not unusual for the tie rod ends to be close. Mud can damage the rubber covers. If it's too close you may need spacers or wheels that are
i will retighten them more..I also noticed that one of the rubber spacers on top of the strut is hamburger..will have to order a new one as well... Overall I think that it was a successful install.
1 - 4 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
PRC Polaris Ranger Club
PRCforum is the best Polaris forum community to discuss RZR 1000, Crew 900, PRC Ranger Club, XP 900, RZR XP 4 900, RZR 570, HD, 170, RZR-S, XP 900, RZR XP 4 900, ORV, side by side, SSW and off-road information.
Full Forum Listing
Recommended Communities
