I just bought a set of tires and aluminum wheels off a 2014 900XP.I am putting them on a 2004 ranger.I know that I have to put the longer wheel studs on.I would like to have an adapter to go from the larger hole to the smaller ones on the newer wheels.If not I will have to ad washers and just rely on the lug nuts for centering the wheels.Does anyone sell this type of adapter?
Ranger wheels
1 - 3 of 3 Posts
Joined
·
6,273 Posts
Haven't seen any pre-built ones but you could probably have some custom made from a place like this: Wheel Adapters | Rim Adapters | Wheel Conversion Parts for Cars & Trucks
You will need a 4/156 to 4/156 with 3/8" holes and 12mmX1.50 studs. Probably will be pricey and will make your wheels stick out further.
You will need a 4/156 to 4/156 with 3/8" holes and 12mmX1.50 studs. Probably will be pricey and will make your wheels stick out further.
http://www.prcforum.com/forum/17-ranger-discussions/52840-wheel-stud-question.html
Wertles did his, and on the last page, I did mine also. I just notched out for the nubs instead of the entire diameter. Cost me less than $100 to convert to larger studs and just time to notch out for them to fit and be lug centered.
Wertles did his, and on the last page, I did mine also. I just notched out for the nubs instead of the entire diameter. Cost me less than $100 to convert to larger studs and just time to notch out for them to fit and be lug centered.
1 - 3 of 3 Posts
