PRC Polaris Ranger Club banner
1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Got a 2018 Polaris ranger 900xp, motor was rebuilt due to low compression on pto cylinder. Reinstalled motor and now it’s only back firing out the exhaust. Have checked fuel pressure, timing, all sensor connections and swapped spark plugs and injectors. All checks out good with no engine codes and working properly. Also drained old gas and put fresh non-ethanol gas in the tank, any insight on what I may be over looking is much appreciated cause this thing is driving me nuts. Do have a video but can’t figure out how to post it on here
 

·
Registered
2015 Polaris ranger 570 XP
Joined
·
3,730 Posts
I would re-check my cam timing.
 
  • Like
Reactions: Jungleman

·
Registered
2015 Polaris ranger 570 XP
Joined
·
3,730 Posts
Yes, cam timing would be off with cams swapped.
 
  • Like
Reactions: Questionsgalore
1 - 4 of 4 Posts
Top