PRC Polaris Ranger Club banner
1 - 1 of 1 Posts

· Registered
1,659 Posts
Discussion Starter · #1 ·
The handle that came w/ my scissor jack was made up of 2 pieces. This sometimes was a PITA. I was looking @ the handle today & had a aha moment. Add a roll pin to retain the "crank" portion. I drilled a hole & installed a 3/16" pin.


  • Like
Reactions: SlimRockett
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.