PRC Polaris Ranger Club banner
1 - 6 of 6 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter · #1 ·
I am not sure that I am posting this on the right site or not but I took the seat belts out of my 2015 900 XP and I needed to either cut the wires and splice them together to make it loop or buy the connection from somebody like one from Dragonfire or somebody like that. I found that a 14-16 gauge split spade electrical terminals, the blue ones, fit perfect in the two slot holes and the I electrical taped over it to hold it in there. Less than .25 cents and now back up to speed with no seat belts or buying a connector. Hope this helps.
 

·
Registered
Joined
·
360 Posts
This is helpful and interesting. Can you post any pics? I will need to do this.
 

·
Registered
Joined
·
74 Posts
I just loop my seat belts behind the backrest, buckle them, and stuff the buckles below the seat and the backrest. Removes the speed limitation problem and they are still there if I want to use them.
 

·
Premium Member
Joined
·
558 Posts
I just loop my seat belts behind the backrest, buckle them, and stuff the buckles below the seat and the backrest. Removes the speed limitation problem and they are still there if I want to use them.
Seems like a simpler, cheaper solution and less work. :)
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top